legacyfert.blogg.se - Windows usb midi monitor

#WINDOWS USB MIDI MONITOR MOD#
#WINDOWS USB MIDI MONITOR SOFTWARE#

Preset Auto Load Setting – Enable this setting (found in ‘Settings – General’ on the screen) to load patches, sequences and FX presets by scrolling and ‘hovering’ on a preset – no click required.

#WINDOWS USB MIDI MONITOR SOFTWARE#

Improved the behaviour and response of the two screen encoders. Free USB Analyzer is a non-intrusive software USB sniffer and protocol analyzer for Windows.

Improved the ‘Glide’ parameter on screen to show when in ‘Auto Glide’ mode compared to ‘Legato’ mode.

Improved interaction between Step Sequence Gate and Step Edit modes.Improved the behaviour of the screen encoder when controlling synced delay times or synced LFO rates so that it increments in the same direction as the dedicated panel controls.

Improved sustain pedal behaviour (prevented potential double triggering of sustain messages).

Improved the stream of MIDI messages from the joystick X axis when ‘Joystick Pitch Bend Out’ is disabled.

Fixes for freezes when connected to an external device through USB.

Fixed issue where a negative MEG Depth could cause issues with FX3.

Fixed issue where chord invert wasn’t being saved to patches.

#WINDOWS USB MIDI MONITOR MOD#

Fixed issue where the ‘Joystick Mod Wheel Out’ setting couldn’t be disabled.Fixed issue on ARGON8M where the joystick axis calibration settings would control the incorrect axes (e.g. The USB MIDI Monitor lets you view all incoming MIDI events from your USB MIDI interface.The X+ setting would calibrate X-, the Y+ setting would calibrate Y-) Fixed issue where the onset / attack of MPE notes may randomly sound incorrect.Fixed issue where changing the ‘Keyboard Local’ setting value would incorrectly change the displayed ‘Arp/Seq Out’ setting value on the screen.Fixed issue where a burst of aftertouch messages was being sent to the MIDI DIN out on boot.Fixed potential issue with setting animator parameters from the app.Fixed issue where the screen control for the osc ‘Tune’ parameters wasn’t incrementing correctly.Fixed hanging notes issue when in MONO mode with the clock source set to MIDI but with no external MIDI clock present.Fixed issue where it was possible to crash the synth by sending it a large number of MIDI notes whilst renaming or confirming a preset save from the screen.Fixed issue where it wasn’t possible to hold the MOD EG button to momentarily perform mod assignments.